Worx LANDROID WG757E Lawn Mower Manual

The Worx LANDROID WG757E is an advanced robotic lawn mower designed to maintain your lawn effortlessly. With its intelligent navigation system, it can handle complex garden layouts, navigate obstacles, and return to its charging station automatically. This manual provides essential information on safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting to the App 7. Operating the Mower 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: Robotic mower, charging station, boundary wire, and user-friendly app.

Feature	Description
Intelligent Navigation	Maps your garden layout for efficient mowing
Weather Sensor	Pauses mowing during rain to protect the mower
Boundary Wire	Defines the mowing area to prevent the mower from going outside
Mobile App Control	Control and schedule mowing from your smartphone
Adjustable Cutting Height	Customize the cutting height for your lawn
Quiet Operation	Operates quietly, allowing for use at any time

Installation

Unpack the mower and accessories. Follow these steps for installation:

Set up the charging station: Place it in a dry area with access to power.
Install boundary wire: Define the mowing area by laying the wire around the perimeter.
Connect the mower to the charging station.

WARNING! Ensure the area is clear of obstacles before mowing.

First-Time Setup

Power on the mower and follow the app instructions for setup.

Download the Worx app and create an account.
Connect the mower to your Wi-Fi network.
Set your mowing schedule through the app.

CAUTION! Ensure the mower is on a flat surface during setup.

Specifications

Cutting Width: 18 cm.
Battery Type: Lithium-ion.
Battery Voltage: 20V.
Charging Time: 90 minutes.
Working Area: Up to 700 m².
Cutting Height: Adjustable from 20 mm to 60 mm.
Weight: 9.5 kg.

Controls and Settings

Access settings via the mobile app or the control panel on the mower.

Control Panel: Power button, manual control buttons, and status indicators.

Settings: Schedule mowing times, adjust cutting height, and set up geofencing.

Connecting to the App

Ensure your smartphone is connected to the same Wi-Fi network as the mower.

Open the Worx app and log in.
Select your mower from the device list.
Follow the prompts to connect and configure settings.

Tip: Keep the app updated for the best performance.

Operating the Mower

To start mowing, ensure the mower is charged and the boundary wire is installed.

Press the power button to turn on the mower.
Use the app to start the mowing schedule.
Monitor the mower's progress through the app.

WARNING! Do not attempt to lift or move the mower while it is operating.

Maintenance

Regular maintenance is essential for optimal performance.

Clean the mower blades after each use.
Check the boundary wire for any damage.
Store the mower indoors during winter months.

CAUTION! Always disconnect the battery before performing maintenance.

Safety Information

Read all safety instructions before operating the mower.

Keep children and pets away from the mowing area.
Do not operate the mower in wet conditions.
Ensure the mower is properly maintained to prevent accidents.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Mower does not start	Battery low	Charge the battery fully.
Boundary wire not detected	Improper installation	Check the boundary wire connections.
Mower stops unexpectedly	Obstacles detected	Clear the mowing area of obstacles.
App connection issues	Wi-Fi problems	Ensure the mower is within Wi-Fi range.

Reset: Refer to the app for reset instructions if needed.

Service: Contact customer support for further assistance.