Worx Landroid M 1000 Lawn Mower Manual

The Worx Landroid M 1000 is an advanced robotic lawn mower designed for efficient and automated lawn care. It features a cutting width of 20 cm, capable of handling lawns up to 1000 square meters. With intelligent navigation, rain sensors, and customizable cutting schedules, it ensures a perfectly manicured lawn with minimal effort. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Mower 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: Robotic mower, charging station, rain sensor, boundary wire, and mobile app connectivity.

FeatureDescription
Cutting Width20 cm for efficient mowing
Battery LifeUp to 90 minutes on a single charge
Rain SensorAutomatically returns to charging station in rain
Mobile AppControl and schedule mowing from your smartphone
Boundary WireDefines the mowing area
Obstacle DetectionAvoids obstacles while mowing
Customizable ScheduleSet mowing times to fit your needs
Eco-FriendlyLow noise and zero emissions

Installation

Unpack and inspect contents. Set up the charging station in a dry area.

  1. Install boundary wire: Lay out the wire around the lawn perimeter.
  2. Connect the charging station: Plug into a power source and ensure it’s level.
  3. Test the mower: Place the mower on the charging station to charge before first use.

WARNING! Ensure the area is clear of obstacles before installation.

First-Time Setup

Power on the mower and follow the on-screen prompts.

  1. Connect to Wi-Fi: Use the mobile app to connect the mower to your home network.
  2. Set mowing schedule: Choose preferred days and times for mowing.
  3. Adjust cutting height: Set the desired height for grass cutting.

CAUTION! Ensure the mower is on a flat surface during setup.

Specifications

Controls and Settings

Access settings via the mobile app or the control panel on the mower.

Control Panel: Power button, manual start, and stop buttons.

Settings: Adjust cutting height, schedule mowing times, and check battery status.

Connecting Devices

Connect the mower to your smartphone via the mobile app for remote control.

  1. Download the Worx Landroid app from the App Store or Google Play.
  2. Create an account or log in.
  3. Follow the prompts to connect your mower to the app.

Tip: Ensure your smartphone is connected to the same Wi-Fi network as the mower.

Operating the Mower

To start mowing, ensure the mower is charged and the boundary wire is set.

  1. Press the power button to turn on the mower.
  2. Use the app to start the mowing session or set a schedule.
  3. Monitor the mower's progress via the app.

WARNING! Do not attempt to lift or move the mower while it is operating.

Maintenance

Regular maintenance is essential for optimal performance.

  1. Clean the mower after each use to remove grass clippings.
  2. Check and replace the blades as needed.
  3. Inspect the boundary wire for damage.

CAUTION! Always turn off the mower before performing maintenance.

Safety Information

Read all safety instructions before operating the mower.

Troubleshooting

SymptomPossible CauseCorrective Action
Mower does not startBattery lowCharge the battery fully before use.
Mower stops unexpectedlyBoundary wire issueCheck the boundary wire for breaks or disconnections.
Uneven cuttingBlades dullSharpen or replace the blades as necessary.
Wi-Fi connection issuesNetwork problemsEnsure the mower is within range of the Wi-Fi router.

Reset: Use the app to reset settings if needed.

Service: For support, contact Worx customer service.

Worx Landroid M 1000 Lawn Mower Manual © - All Rights Reserved 2026