Worx NITRO WG749E Lawn Mower Manual

The Worx NITRO WG749E is a powerful and efficient lawn mower designed for easy and effective grass cutting. This model features a 40V lithium battery, a 20-inch cutting deck, and a lightweight design for maneuverability. It includes adjustable cutting heights, a grass collection bag, and a mulching capability. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: 20-inch cutting deck, 40V lithium battery, adjustable cutting heights, grass collection bag, mulching capability.

Installation

Unpack and inspect contents. Ensure all parts are included.

1. Attach the handle: Align and secure the handle to the mower body.
2. Install the battery: Insert the battery into the designated compartment.
3. Check oil levels: Ensure oil is at the recommended level before use.
4. Charge the battery: Fully charge the battery before first use.

WARNING! Read the safety instructions before operating the mower.

First-Time Setup

Power on the mower; follow the setup instructions.

1. Set the desired cutting height: Adjust the lever to your preferred height.
2. Check battery charge: Ensure the battery is fully charged before mowing.
3. Perform a safety check: Inspect the mower for any loose parts.

CAUTION! Always wear appropriate safety gear when operating the mower.

Specifications

• Cutting Width: 20 inches.
• Power Source: 40V lithium battery.
• Cutting Heights: Adjustable from 1 inch to 3.5 inches.
• Weight: Approximately 40 lbs.
• Grass Collection Bag Capacity: 14 gallons.
• Charging Time: 2 hours for a full charge.
• Runtime: Up to 45 minutes on a full charge.

Controls and Settings

Access controls via the handle: Power button, cutting height adjustment lever, and safety key.

Battery Indicator: Displays battery charge level during operation.

Settings: Adjust cutting height before starting the mower for optimal performance.

Connecting Devices

Battery: Ensure the battery is properly connected before use.

1. Turn off the mower before connecting or disconnecting the battery.
2. Ensure all connections are secure.

Tip: Always check battery charge before starting your mowing session.

Operating the Mower

Follow these steps to operate the mower effectively.

1. Power on the mower: Insert the safety key and press the power button.
2. Adjust cutting height: Set to your desired height before mowing.
3. Mow the lawn: Move the mower forward at a steady pace.
4. Empty the grass collection bag: Check and empty when full.

WARNING! Do not operate the mower in wet conditions.

Maintenance

Regular maintenance is essential for optimal performance.

1. Clean the mower after each use: Remove grass clippings and debris.
2. Check battery regularly: Ensure it is charged and in good condition.
3. Inspect blades: Sharpen or replace blades as needed.

CAUTION! Always disconnect the battery before performing maintenance.

Care & Cleaning

Unplug and remove the battery before cleaning. Use a dry cloth only; no liquids or aerosols.

CAUTION! Do not spray liquids; keep away from heat and moisture.

Regulatory Information

This product complies with all applicable safety standards and regulations. For support, visit www.worx.com or contact customer service.

Troubleshooting

Reset: If issues persist, refer to the troubleshooting section or contact support.

Service: For assistance, call customer support or visit the website.