Worx WG745 Series Lawn Mower Manual

The Worx WG745 Series is a cordless lawn mower designed for efficient grass cutting with a 40V battery system. It features a 20-inch cutting deck, adjustable cutting heights, and a lightweight design for easy maneuverability. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Mower 8. Maintenance 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: 20-inch cutting deck, 40V battery, adjustable cutting height, lightweight design, and ergonomic handle.

Feature	Description
20-inch Cutting Deck	Wide cutting area for efficient mowing
40V Battery	Powerful battery for extended run time
Adjustable Cutting Height	Multiple height settings for different grass lengths
Lightweight Design	Easy to maneuver and transport
Ergonomic Handle	Comfortable grip for reduced fatigue

Installation

Unpack and inspect contents. Ensure all parts are included.

Attach the handle: Align and secure the handle to the mower body.
Insert the battery: Ensure the battery is fully charged and properly inserted.
Check safety features: Ensure all safety guards are in place.

WARNING! Always wear appropriate safety gear when operating the mower.

First-Time Setup

Power on the mower; follow the instructions for initial setup.

Charge the battery: Connect the charger and ensure the battery is fully charged.
Adjust cutting height: Set the desired cutting height before mowing.
Test operation: Start the mower and ensure it operates smoothly.

CAUTION! Ensure the area is clear of obstacles before mowing.

Specifications

Cutting Width: 20 inches.
Battery Voltage: 40V.
Weight: Approximately 40 lbs.
Cutting Heights: Adjustable from 1 inch to 3.5 inches.
Run Time: Up to 45 minutes on a full charge.
Charging Time: Approximately 2 hours.

Controls and Settings

Access controls via the handle: Power button, height adjustment lever, and safety switch.

Power Button: Starts and stops the mower.

Height Adjustment Lever: Adjusts the cutting height easily.

Connecting Devices

Battery: Ensure the battery is properly connected before use.

Turn off the mower before connecting or disconnecting the battery.
Ensure connections are secure.

Tip: Always check battery charge before starting.

Operating the Mower

Follow these steps for safe operation:

Start the mower: Press the power button to start.
Mow: Move the mower in a straight line for best results.
Stop: Release the power button to stop the mower.

WARNING! Do not operate on wet grass or slopes.

Maintenance

Regular maintenance ensures optimal performance.

Clean the mower after each use: Remove grass clippings and debris.
Check battery regularly: Ensure it is charged and in good condition.
Inspect blades: Sharpen or replace as needed.

Care & Cleaning

Unplug and remove the battery before cleaning. Use a dry cloth only; no liquids or aerosols.

CAUTION! Do not spray liquids; keep away from heat and moisture.

Regulatory Information

This product complies with all applicable safety standards and regulations. For support, visit www.worx.com or contact customer service.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Mower does not start	Battery dead	Charge the battery and try again.
Uneven cut	Incorrect height setting	Adjust the cutting height.
Grass clippings not collected	Bag full or clogged	Empty the bag and clean the chute.
Excessive vibration	Loose parts	Check and tighten all screws and bolts.

Reset: Refer to the manual for reset instructions if available.

Service: For service inquiries, contact customer support.