Worx WG785E Lawn Mower Manual

The Worx WG785E is a cordless lawn mower designed for efficient grass cutting with a 40V lithium battery. It features a 20-inch cutting deck, adjustable cutting heights, and a lightweight design for easy maneuverability. The mower is equipped with a mulching function, grass collection bag, and a safety key to prevent accidental starts. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Mower 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: 20-inch cutting deck, 40V lithium battery, adjustable cutting heights, mulching capability, grass collection bag.

FeatureDescription
20-inch cutting deckWide cutting area for efficient mowing
40V lithium batteryLong-lasting power for extended mowing sessions
Adjustable cutting heightsCustomizable grass length settings
Mulching functionChops grass clippings into fine pieces for nutrient recycling
Grass collection bagCollects clippings for easy disposal
Safety keyPrevents accidental starts for user safety

Installation

Unpack the mower and ensure all parts are included. Charge the battery fully before first use.

  1. Attach the handle: Align and secure the handle to the mower body.
  2. Insert the battery: Ensure the battery is properly seated in the compartment.
  3. Check safety features: Ensure the safety key is in place before starting.

WARNING! Read the manual thoroughly before operating the mower. Wear appropriate safety gear.

First-Time Setup

Power on the mower; follow the instructions for initial settings.

  1. Charge the battery: Connect the charger and wait for the indicator light to show full charge.
  2. Adjust cutting height: Set the desired height using the adjustment lever.
  3. Perform a test run: Start the mower and check for proper operation.

CAUTION! Ensure the area is clear of obstacles before mowing.

Specifications

Controls and Settings

Access controls via the handle: Power switch, height adjustment lever, and safety key.

Power Switch: Located on the handle for easy access.

Height Adjustment: Use the lever to set the desired cutting height.

Connecting Devices

Ensure the battery is charged before connecting any accessories.

  1. Turn off the mower before connecting any devices.
  2. Follow the manufacturer's instructions for any additional attachments.

Tip: Always check compatibility with the Worx WG785E before purchasing accessories.

Operating the Mower

Follow these steps for safe and effective mowing.

  1. Start the mower: Insert the safety key and press the power switch.
  2. Begin mowing: Move the mower forward at a steady pace.
  3. Adjust speed as necessary: Maintain a consistent speed for even cutting.
  4. Stop the mower: Release the power switch to turn off.

WARNING! Do not operate the mower on wet grass or slopes.

Maintenance

Regular maintenance ensures optimal performance.

  1. Clean the mower after each use: Remove grass clippings and debris.
  2. Check battery health: Inspect for any signs of wear or damage.
  3. Sharpen blades: Maintain sharp blades for effective cutting.

CAUTION! Always disconnect the battery before performing maintenance.

Safety Information

Read all safety instructions before operating the mower.

Troubleshooting

SymptomPossible CauseCorrective Action
Mower won't startBattery dead/safety key missingCharge battery/check safety key.
Uneven cuttingBlades dull/incorrect heightSharpen blades/adjust height.
Grass clippings not collectedBag full/mulching mode engagedEmpty bag/check settings.
Excessive vibrationLoose parts/damaged bladesInspect and tighten/replace blades.

Reset: Refer to the manual for reset instructions if available.

Service: Contact Worx customer support for assistance.

Worx WG785E Lawn Mower Manual © - All Rights Reserved 2026